Payment & Shipping Terms:
|Applied Standard:||IEC 61032||Applied Figure:||Figure 1|
|Sphere Diameter:||Ф50mm||Sphere Material:||Metal|
|Handle Material:||Nylon||Applied Force:||Should Work With Force Gauge|
50mm Rigid Sphere Test Probe A,
IEC 61032 Sphere Test Probe A
IEC 61032 Figure 1 Test Probe A
This test probe A conforms to the standard requirements of IEC61032 fig.1, IEC60529 IP1 and IEC60065, etc. This probe is intended to verify the protection of persons against access to hazardous parts. It is also used to verify the protection against access with the back of the hand.
|Name||Test probe A|
|Sphere diameter (mm)||SФ50+0.05 0|
|Guard diameter (mm)||Ф45±0.2|
|Handle diameter (mm)||Ф10|
|Guard thickness (mm)||4|
|Handle length (mm)||100|
|Sphere material||Rigid metal|
|Guard and handle material||Nylon|
Please refer to the relevant standards.
Take IEC 60529:2013 clause 13.2 as an example:
The object probe is pushed against any openings of the enclosure with the force specified in table 7.
The test probe doesn’t have built-in force, if specific applied force required, the test probe should work together with a force gauge. At the end of our probe handle, there is a M6 thread hole to match the force gauge. Showing as following reference picture:
For verifying whether LIVE PARTS touched, the probe is equipped with amphenol connector, recommended to work with our anti-shock probe experiment device or a 40~50V voltage indicator. Showing as following reference picture:
Contact Person: Manager